System Time Changes

IWATSU

Adix VS

From the Operator DSS when idle:

1. Press [ICM] + [FEAT] + [6] + [4]
2. Enter the time [HH MM] using the 24 hour military clock
3. Press [SPKR]

From the Attendant Console when idle:

1. Press [ETC] + [ETC] + [ETC] + [F1]
2. Enter the time [HH MM] using the 24 hour military clock
3. Press [RLS]

ZTD:

From the operator only when idle:

1. Go off-hook and press [FEAT] + [SPKR] + [3]
2. Enter the time [HH MM] using the 24 hour military clock
3. Go on-hook

ZTS:

From the Master KT only, when idle:

1. Go off-hook and press [FEAT] + [#] + [2]
2. Enter the time [HH MM] using the 24 hour military clock
3. Go on-hook

Sprint

Protege:

1. Enter Attendant Programming...
   Function
   #
   0
   0000
   Tenant group 1.
2. Press soft key F2 below the word "next" until "System Time" is displayed.
3. Press soft key F3 below the word "show".
4. Press soft key F3 below the word "change" if you wish to change a particular setting. Use the dial pad to enter the appropriate two-digit numbers for the year, day, hour, and minute settings. Months and weekdays can be scrolled by pressing soft key F3 repeatedly until the desired setting is displayed.
5. Press soft key F2 when you have made your selection to advance to the next category.
6. Press the hold key to exit at any point.

Lucent Technologies

PARTNER II:

1. Press the PROGRAM key and dial 7.
2. Enter a two digit HOUR (00-23).
3. Enter a two digit MINUTE (00-59).
4. Press * to exit the programming mode.